AUTOMATIC TRANSAXLE SYSTEM > MONITOR DRIVE PATTERN |
| TEST MONITOR DRIVE PATTERN FOR ECT |
Preparation for driving
Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).
Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.
Malfunctions are not detected when the atmospheric temperature is below -10°C (14°F).
Drive pattern
Drive the vehicle through all the gears.
Stop → 1st → 2nd → 2nd (lock-up on) → 3rd → 3rd (lock-up on) → 4th → 4th (lock-up on) → 5th → 5th (lock-up on) → 6th → 6th (lock-up on).
Perform the engine brake test with the shift lever in D. While driving in 6th gear lock-up, operate the "-" shift paddle switch and down-shift from 6th → 5th, 5th → 4th, 4th → 3rd, 3rd → 2nd and 2nd → 1st.
Check that the engine brake operates properly when each down-shift takes place.
Repeat the above drive pattern 3 times or more.
