DTC P0500 Vehicle Speed Sensor "A" |

| DTC Code | DTC Detection Condition | Trouble Area |
| P0500 | When the engine coolant temperature sensor is normal and the counter gear speed is 300 rpm or more, the vehicle speed signal is not input for 2 seconds or more (1-trip detection logic). |
|

| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Drive the vehicle and check whether the operation of the speedometer in the combination meter assembly is normal.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
Drive the vehicle.
Read the value displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Actual vehicle speed | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK COMBINATION METER ASSEMBLY (SPD SIGNAL WAVEFORM) |
![]() |
Remove the combination meter assembly with the connector(s) still connected.
Move the shift lever to N.
Jack up the vehicle.
Turn the ignition switch to ON.
Check the signal waveform according to the condition(s) in the table below.
| Terminal No. (Symbol) | Tool Setting | Condition |
| E22-39 (+S) - Body ground | 2 V/DIV., 20 msec./DIV. | Vehicle speed 20 km/h (12 mph) |
| *1 | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TCM) |
![]() |
Disconnect the combination meter assembly connector.
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E22-39 (+S) - B128-3 (SPD) | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Combination Meter Assembly) |
| *2 | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||