DTC P0724 Brake Switch "B" Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Accelerate the vehicle to 30 km/h (19 mph) or more, depress the brake pedal and decelerate the vehicle to 3 km/h (1.8 mph) or less 5 times. | Stop light switch remains on even when vehicle is driven in GO (30 km/h (19 mph) or more) and STOP (less than 3 km/h (1.8 mph)) pattern 5 times. (2 trip detection logic) |
|
| DTC No. | Data List |
| P0724 | Stop Light Switch |

| 1.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Stop Light Switch.
Read the value displayed on the tester when the brake pedal is depressed and released.
| Brake Pedal | Display |
| Released | OFF |
| Depressed | ON |
|
| ||||
|
| ||||
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| Switch pin pushed | 10 kΩ or higher | |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch.
|
| ||||
| OK | |
| 3.CHECK ECM (STP VOLTAGE) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Condition | Specified Condition |
| A12-35 (STP) - Body ground | Released | 0 to 3 V |
| Depressed | 11 to 14 V |
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPLACE STOP LIGHT SWITCH ASSEMBLY |
Replace the stop light switch assembly (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON and turn the tester on.
Start the engine.
Accelerate the vehicle to 30 km/h (19 mph) or more, depress the brake pedal and decelerate the vehicle to 3 km/h (1.8 mph) or less 5 times or more.
Confirm that the DTC is not output again.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input DTC P0724.
Check that STATUS is NORMAL.
| NEXT | ||
| ||