DTC P0504 Brake Switch "A" / "B" Correlation |
| Signals | Brake Pedal Released | In Transition | Brake Pedal Depressed |
| STP | OFF | ON | ON |
| ST1- | ON | ON | OFF |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Release and depress brake pedal with ignition switch ON | Conditions (a), (b) and (c) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch ON. (b) Brake pedal is released. (c) The STP signal is off when the ST1- signal is off, or the STP signal is on when the ST1- signal is on. |
|
| DTC No. | Data List |
| P0504 | Stop Light Switch |

| Brake Pedal Operation | Specified Condition |
| Depressed | ON |
| Released | OFF |
| 1.CHECK STOP LIGHT SWITCH ASSEMBLY (TERMINAL B VOLTAGE) |
![]() |
Disconnect the stop light switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A66-2 - Body ground | Always | 11 to 14 V |
| A66-4 - Body ground | Ignition switch ON | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Switch) |
Reconnect the stop light switch connector.
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| Switch pin pushed | 10 kΩ or higher | |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch.
|
| ||||
| OK | |
| 3.CHECK ECM (STP AND ST1- VOLTAGE) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Condition | Specified Condition |
| A12-34 (ST1-) - Body ground | Released | 11 to 14 V |
| Depressed | 0 to 3 V | |
| A12-35 (STP) - Body ground | Released | 0 to 3 V |
| Depressed | 11 to 14 V |
Reconnect the ECM connector.
|
| ||||
|
| ||||
| 4.REPLACE STOP LIGHT SWITCH ASSEMBLY |
Replace the stop light switch assembly (Click here).
|
| ||||
| 5.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON and turn the tester on.
Release and depress the brake pedal.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||