Home › ENGINE · 2AD-FTV › STARTING › ENTRY AND START SYSTEM

DTC    B2272    Ignition 1 Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction occurs in the IG output circuit, which is between the IG1 relay actuation circuit inside the main body ECU and the IG1 relay.

DTC Code
DTC Detection Condition
Trouble Area
B2272
IG1 relay actuation circuit inside the main body ECU or other related circuit is malfunctioning.
  1. Main body ECU
  2. IG1 relay
  3. Harness or connector

WIRING DIAGRAM


A165871E05


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (IG1 RELAY MONITOR [INSIDE])
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnosis Note
    IG1 Relay Monitor(Inside)
    IG1 inner relay monitor/ON or OFF
    ON: Engine switch on (IG)
    OFF: Engine switch off
    -

    OK:
    When the engine switch is turned on (IG), ON is displayed on the intelligent tester.



NG
Go to step 3
OK


2.CHECK SWITCH CONDITION (ENGINE SWITCH)
  1. Make sure that the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the engine switch is pushed.

    OK:
    off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.INSPECT IG1 RELAY


    B112776E02
  1. Remove the IG1 relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher



NG
REPLACE IG1 RELAY
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)