DTC B2273 Ignition 2 Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2273 | IG2 relay actuation circuit inside the main body ECU or other related circuit is malfunctioning. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (IG2 RELAY MONITOR [INSIDE]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG2 Relay Monitor(Inside) | IG2 inner relay monitor/ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off | - |
|
| ||||
| OK | |
| 2.CHECK SWITCH CONDITION (ENGINE SWITCH) |
Make sure that the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the engine switch is pushed.
|
| ||||
| OK | ||
| ||
| 3.INSPECT IG2 RELAY |
![]() |
Remove the IG2 relay from the engine room No. 1 relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (IG2 RELAY - MAIN BODY ECU AND BODY GROUND) |
![]() |
Remove the IG2 relay from the engine room No. 1 relay block.
Disconnect the E19 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Relay block IG2 relay terminal 1 - E19-5 (IG2D) | Always | Below 1 Ω |
| Relay block IG2 relay terminal 2 - Body ground | Always | Below 1 Ω |
| Relay block IG2 relay terminal 1 or E19-5 (IG2D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||