AIRBAG SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (USING SST (CHECK WIRE)) |
![]() |
Check the DTCs (Present trouble code).
Turn the ignition switch on (IG), and wait for approximately 60 seconds.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Check the DTCs (Past trouble code)
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch on (IG), and wait for approximately 60 seconds.
Read the DTCs.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and DTCs 11 and 21 are shown in the illustration to the above.
| CLEAR DTC (USING SST (CHECK WIRE)) |
Clear the DTCs.
When the ignition switch is turned off, the DTCs are cleared.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3, and then turn the ignition switch on (IG).
Disconnect terminal 13 (TC) of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds.
Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (TC) and 4 (CG) of the DLC3.
The SRS warning light should go off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Then, disconnect terminal 13 (TC) within 2 to 4 seconds after the SRS warning light goes off.
The SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13 (TC). Then, reconnect terminals 13 (TC) and 4 (CG) within 2 to 4 seconds after the SRS warning light comes on.
Check if the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Also check if the normal system code is output within 1 second after the SRS warning light goes off.
If DTCs are not cleared, repeat this procedure until the codes are cleared.

| CHECK DTC (USING INTELLIGENT TESTER) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Check the DTCs by following the prompts on the tester screen.
| CLEAR DTC (USING INTELLIGENT TESTER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Clear the DTCs by following the prompts on the tester screen.