DTC C1243/43 Acceleration Sensor Stuck Malfunction |
DTC C1244/44 Open or Short in Deceleration Sensor Circuit |
DTC C1245/45 Acceleration Sensor Output Malfunction |
DTC C1279/79 Acceleration Sensor Output Voltage Malfunction (Test Mode DTC) |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1243/43 | While vehicle speed decreases from 30 km/h (18 mph) to 0 km/h (0 mph), condition that ECU terminal GL1 value does not change to 0.0294 G or more occurs 16 times consecutively. |
|
| C1244/44 | When one of following conditions is met:
|
|
| C1245/45 | At vehicle speed of 30 km/h (18 mph) or more, difference between back and forth G value calculated using G sensor signals and back and forth G value calculated using vehicle speed, exceeds 0.35 G for 60 seconds or more. |
|
| C1279/79 | Detected only during test mode |
|

| 1.READ VALUE USING INTELLIGENT TESTER (DECELERATION SENSOR) |
Check the Data List for proper functioning of the deceleration sensor.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Deceleration Sensor | Deceleration sensor reading / Min.: -18.52 m/s2, Max.: 18.39 m/s2
| - | Reading changes when vehicle is shaken |
|
| ||||
| OK | ||
| ||
| 2.INSPECT DECELERATION SENSOR |
![]() |
Remove the deceleration sensor.
Connect 3 dry cell batteries of 1.5 V in series.
Check the output voltage of terminal 1 (GL1) when the sensor is tilted forward and rearward.
| Tester Connection | Sensor Position | Specified Condition |
| 1 (GL1) - Battery's negative (-) lead | Horizontal | Approx. 2.3 V |
| 1 (GL1) - Battery's negative (-) lead | Tilted forward | Approx. 0.4 to 2.3 V |
| 1 (GL1) - Battery's negative (-) lead | Tilted rearward | Approx. 2.3 to 4 V |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SKID CONTROL ECU - DECELERATION SENSOR) |
![]() |
Disconnect the A27 ECU connector.
Disconnect the K7 sensor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A27-4 (GL1) - K7-1 (GL1) | Below 1 Ω |
| A27-7 (GGND) - K7-2 (GGND) | Below 1 Ω |
| A27-28 (VGS) - K7-3 (VGS) | Below 1 Ω |
| K7-1 (GL1) - Body ground | 10 kΩ or higher |
| K7-2 (GGND) - Body ground | 10 kΩ or higher |
| K7-3 (VGS) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK FOR DTC |
Install the deceleration sensor to the vehicle.
Clear the DTCs (Click here).
Drive the vehicle at 6 km/h (4 mph) or more.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||