VEHICLE STABILITY CONTROL SYSTEM > TS and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU/BODY GROUND) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-4 (CG) - Body ground | Always | Below 1 Ω |
| E16-12 (TS) - A67-33 (TS) | Always | Below 1 Ω |
| A67-33 (TS) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||