Home › TRANSMISSION ยท CLUTCH › CLUTCH PEDAL (for LHD)

CLUTCH PEDAL (for LHD) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH PEDAL ASSEMBLY


C125481E01
  1. Install the clutch pedal.

  1. Install the bolt and 2 nuts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for nut A
    24 N*m{ 245 kgf*cm , 18 ft.*lbf } for bolt B



2. INSTALL PUSH ROD CLEVIS PIN


C206282
  1. Install the pin and a new clip.



3. CONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System)
  1. Install the clutch start switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch start switch connector.



4. CONNECT CLUTCH SWITCH CONNECTOR (w/ Cruise Control System)
  1. Install the clutch switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch switch connector.



5. INSTALL UPPER INSTRUMENT PANEL
  1. Install the upper instrument panel (Click here).



6. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)


B127987
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the driver side knee airbag with the 4 bolts.

    Torque:
    10 N*m{ 101 kgf*cm , 7 ft.*lbf }



7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B129996
  1. Attach 3 claws to install the instrument panel under cover.

  1. Install the 2 screws.



8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


B132919
  1. Attach the 8 claws to install the lower instrument panel finish panel.

  1. Install the 2 screws.



9. CHECK FLUID LEVEL IN RESERVOIR
  1. Check the fluid level in the reservoir (Click here).