Home › TRANSMISSION ยท CLUTCH › CLUTCH PEDAL (for RHD)

CLUTCH PEDAL (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH PEDAL ASSEMBLY


C128470E04
  1. Install the clutch pedal.

  1. Install the 2 bolts and 2 nuts.

    Torque:
    for bolt A:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }
    for bolt B:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }
    for nut:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



2. CONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System)
  1. Install the clutch start switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch start switch connector.



3. CONNECT CLUTCH SWITCH CONNECTOR (w/ Cruise Control System)
  1. Install the clutch switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch switch connector.



4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)


B127987
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the driver side knee airbag with the 4 bolts.

    Torque:
    10 N*m{ 101 kgf*cm , 7 ft.*lbf }



5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


B132919
  1. Attach the 8 claws to install the lower instrument panel finish panel.

  1. Install the 2 screws.



6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B129996
  1. Attach 3 claws to install the instrument panel under cover.

  1. Install the 2 screws.



7. INSTALL UPPER INSTRUMENT PANEL
  1. Install the upper instrument panel (Click here).



8. CHECK FLUID LEVEL IN RESERVOIR
  1. Check the fluid level in the reservoir (Click here).