Home › ENGINE ยท 2AD-FTV › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL FRONT CRANKSHAFT OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.

    NOTICE:
    Keep the lip free of foreign objects.



    A202326E01
  1. Using SST and a hammer, tap in the oil seal as shown in the illustration.

    SST
    09223-50010  

    Standard depth:
    0 to 0.6 mm (0 to 0.0236 in.)

    NOTICE:
    1. Do not tap the oil seal at an angle.
    2. Wipe off extra grease on the crankshaft.



2. INSTALL CRANKSHAFT PULLEY
  1. Align the keyway of the pulley with the key located on the crankshaft, then slide the pulley into place.



    A205839E01
  1. Using SST, install the pulley bolt.

    SST
    09213-58014  
    09330-00021  

    Torque:
    300 N*m{ 3059 kgf*cm , 221 ft.*lbf }



3. INSTALL FAN AND GENERATOR V BELT
  1. Install the fan and generator V belt (Click here).