Home › ENGINE ยท 2AD-FHV › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
  1. Remove the manual transaxle (Click here).



3. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)
  1. Remove the automatic transaxle (Click here).



4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)


    C113575E07
  1. Align the matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt 180°at a time until the spring tension is released.

    NOTICE:
    Following the order in the illustration, make sure to uniformly loosen the bolts 180°at a time.

  1. Remove the set bolts, and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.



6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    A201753E01
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-58014   (91551-80840)
    09330-00021  



    A202344
  1. Using a T55 "TORX" socket wrench, remove the 8 bolts and flywheel.



7. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)


    A201753E01
  1. Hold the crankshaft pulley with SST.

    SST
    09213-58014   (91551-80840)
    09330-00021  



    A208894
  1. Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear and front drive plate spacer.



8. REMOVE REAR CRANKSHAFT OIL SEAL


    A123733E01
  1. Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft.