Home › TRANSMISSION ยท EA64F MANUAL TRANSAXLE › MANUAL TRANSAXLE ASSEMBLY

MANUAL TRANSAXLE ASSEMBLY > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE FRONT WHEEL


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



4. DRAIN TRANSAXLE OIL
  1. Remove the filler plug and gasket.

  1. Remove the drain plug and gasket, and drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



5. DRAIN TRANSFER OIL
  1. Remove the drain plug and gasket, and drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



6. REMOVE BACK-UP LIGHT SWITCH


    C112470
  1. Disconnect the back-up light switch connector.



    C112471E01
  1. Using SST, remove the back-up light switch and gasket from the transaxle.

    SST
    09816-30010  



7. DISCONNECT CLUTCH RELEASE CYLINDER


C127500
  1. Remove the 2 bolts and clutch release cylinder.



8. REMOVE STARTER ASSEMBLY
  1. for 2AD-FTV:
    Remove the starter (Click here).

  1. for 2AD-FHV:
    Remove the starter (Click here).



9. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY


C127238E02
  1. Remove the 2 clips and 2 washers, and disconnect the 2 cables from the transaxle.

  1. Remove the 2 clips, and disconnect the 2 cables from the bracket.



10. REMOVE ENGINE ASSEMBLY WITH MANUAL TRANSAXLE
  1. for 2AD-FTV:
    Remove the engine with transaxle (Click here).

  1. for 2AD-FHV:
    Remove the engine with transaxle (Click here).



11. REMOVE ENGINE MOUNTING BRACKET LH


C129227
  1. Remove the 4 bolts and mounting bracket.



12. REMOVE OIL PAN INSULATOR


C127239
  1. Remove the 2 bolts and insulator from the stiffener plate.



13. REMOVE STIFFENER PLATE LH


C127240
  1. Remove the 4 bolts and stiffener plate from the engine and transaxle assembly.



14. REMOVE STIFFENER PLATE RH


C127241
  1. Remove the 4 bolts and stiffener plate from the engine and transaxle assembly.



15. REMOVE MANUAL TRANSAXLE ASSEMBLY


C112442
  1. Remove the 5 bolts.

  1. Separate and remove the transaxle from the engine.



16. REMOVE FRONT ENGINE MOUNTING BRACKET


C129225
  1. Remove the 3 bolts and mounting bracket.



17. REMOVE REAR ENGINE MOUNTING BRACKET


C129379
  1. Remove the 4 bolts and mounting bracket.



18. REMOVE TRANSFER ASSEMBLY


C126622
  1. Remove the 6 nuts, 2 bolts and transfer from the transaxle.