Home › BRAKE › BRAKE › VACUUM PUMP

VACUUM PUMP > INSTALLATION

for Preparation Click here



1. INSTALL VACUUM PUMP ASSEMBLY


    C128548E01
  1. Apply engine oil to the oil pipe at the tip of the vacuum pump.

  1. Coat 2 new O-rings with engine oil, and install them to the vacuum pump.



    C128549E01
  1. Install the vacuum pump so that the coupling teeth of the vacuum pump (labeled A) and the groove of the camshaft (labeled B) can engage.



    C128547
  1. Install 3 new flange bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 vacuum hoses.



2. INSTALL ENGINE WITH TRANSAXLE (for 2AD-FTV)
  1. Install the engine with transaxle (Click here).



3. INSTALL ENGINE WITH TRANSAXLE (for 2AD-FHV)
  1. Install the engine with transaxle (Click here).



4. INSPECT VACUUM PUMP OPERATION
  1. Disconnect the vacuum hose from the vacuum pump.



    C128546E01
  1. Connect the hose of the vacuum gauge to the vacuum pump.

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, check the negative pressure of the vacuum pump.

    Standard pressure:
    More than 86.7 kPa (650 mmHg, 26 in.Hg)

    HINT:
    It is necessary to replace the vacuum pump every 200,000 km (124,000 miles).

  1. Remove the vacuum gauge from the vacuum pump.

  1. Connect the vacuum hose to the vacuum pump.