DTC P0606 ECM / PCM Processor |
DTC P060A Internal Control Module Monitoring Processor Performance |
DTC P060B Internal Control Module A/D Processing Performance |
DTC P1607 Cruise Control Input Processor |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 1 second | ECM internal error continues for 1 second. (1 trip detection logic) | ECM |
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||