Home › ENGINE ยท 2AD-FHV › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    P0606    ECM / PCM Processor

DTC    P060A    Internal Control Module Monitoring Processor Performance

DTC    P060B    Internal Control Module A/D Processing Performance

DTC    P1607    Cruise Control Input Processor

for Preparation Click here


DESCRIPTION


P0606, P060A, P060B, P1607 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch ON for 1 second
ECM internal error continues for 1 second.
(1 trip detection logic)
ECM

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

1.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the intelligent tester to the DLC3.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off for 30 seconds or more.

  1. Turn the ignition switch to ON for 1 second.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Confirm that the DTC is not output again.


NEXT

END