DTC P0116 Engine Coolant Temperature Circuit Range / Performance Problem |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| City driving for 10 minutes or more after engine start with engine coolant temperature between -40°C (-40°F) and 60°C (140°F) | If the engine coolant temperature is between -40°C (-40°F) and 60°C (140°F) at engine start, and conditions (a) and (b) are met (2 trip detection logic): (a) Vehicle is driven at varying speeds (accelerating and decelerating) for 600 seconds. (b) Engine coolant temperature remains within 3°C (5.4°F) of the engine starting temperature. | Engine coolant temperature sensor |
| City driving for 10 minutes or more after engine start with engine coolant temperature more than 60°C (140°F) | If the engine coolant temperature is more than 60°C (140°F) at engine start, and conditions (a) and (b) are met (6 trip detection logic): (a) Vehicle is driven at varying speeds (accelerating and decelerating) for 600 seconds. (b) Engine coolant temperature remains within 1°C (1.8°F) of the engine starting temperature. |
| DTC No. | Data List |
| P0116 | Coolant Temp |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0116 is output | A |
| P0116 and other DTCs are output | B |
|
| ||||
| A | |
| 2.REPLACE ENGINE COOLANT TEMPERATURE SENSOR |
Replace the engine coolant temperature sensor (Click here).
| NEXT | |
| 3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Start the engine.
Run the engine at 2500 rpm with no load.
Check that "Coolant Temp" changes by 1°C (1.8°F) or more while idling the engine within 10 minutes.
| NEXT | ||
| ||