DTC P0168 Fuel Temperature Too High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Drive vehicle at high speed or with heavy load (Use freeze frame data from time malfunction occurred as reference while driving) | The fuel temperature is 110°C (230°F) or higher for 1 second or more. (1 trip detection logic) | Fuel temperature sensor |
| DTC No. | Data List |
| P0168 | Fuel Temperature |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0168) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0168 is output | A |
| P0168 and other DTCs are output | B |
|
| ||||
| A | |
| 2.REPLACE FUEL SUPPLY PUMP (FUEL TEMPERATURE SENSOR) |
Replace the fuel supply pump (Click here).
| NEXT | |
| 3.BLEED AIR FROM FUEL SYSTEM |
Bleed the air from the fuel system .
| NEXT | |
| 4.PERFORM FUEL SUPPLY PUMP INITIALIZATION |
Perform fuel supply pump initialization (Click here).
| NEXT | |
| 5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Fuel Temperature.
Stop the engine, and then allow it to soak for 30 minutes or more.
Start the engine.
Run the engine at 2500 rpm with no load.
Check that "Fuel Temperature" changes by 1°C (1.8°F) or more while 2500 rpm no load within 10 minutes.
| NEXT | ||
| ||