Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2171/71    Transmitter ID not Registered in Main Mode

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C2171/71
Transmitter ID code is not registered (when an ID code is unregistered for 51 minutes or more)
Tire pressure warning ECU and receiver

INSPECTION PROCEDURE

NOTICE:
It is necessary to register an ID code after replacing the tire wheel and/or the tire pressure monitor ECU and receiver (Click here).

HINT:
Set the tire pressure to the specified value.

Standard pressure:
220 kPa (2.2 kgf/cm2, 32 psi)

1.READ VALUE USING INTELLIGENT TESTER (REGISTERED ID CODES)
  1. Check the Data List for proper functioning of the registered ID codes.

    Tire pressure warning ECU and receiver:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Registered ID1 Code
    Registered ID1 code/
    min.: 0
    max.: FFFFFFF*
    The ID No. registered in the transmitter ID1 is displayed
    -
    Registered ID2 Code
    Registered ID2 code/
    min.: 0
    max.: FFFFFFF*
    The ID No. registered in the transmitter ID2 is displayed
    -
    Registered ID3 Code
    Registered ID3 code/
    min.: 0
    max.: FFFFFFF*
    The ID No. registered in the transmitter ID3 is displayed
    -
    Registered ID4 Code
    Registered ID4 code/
    min.: 0
    max.: FFFFFFF*
    The ID No. registered in the transmitter ID4 is displayed
    -

    HINT:
    *: Displayed only when the ID No. is not registered.

    OK:
    The registered transmitter ID codes are displayed on the intelligent tester screen.



OK
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
NG


2.PERFORM REGISTRATION (TRANSMITTER ID)
  1. Register the transmitter IDs for all the wheels (Click here).

  1. Set the pressure of each tire to the specified value.

    Standard pressure:
    220 kPa (2.2 kgf/cm2, 32 psi)


NEXT


3.READ VALUE USING INTELLIGENT TESTER (TIRE PRESSURE)
  1. Select "ID Tire Inflation Pressure" by following the prompts displayed on the intelligent tester.

    Tire pressure warning ECU and receiver:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ID1 Tire Inflation Pressure
    ID1 tire inflation pressure/
    min.: -100 kPa (-1 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire pressure
    If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*
    ID2 Tire Inflation Pressure
    ID2 tire inflation pressure/
    min.: -100 kPa (-1 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire pressure
    If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*
    ID3 Tire Inflation Pressure
    ID3 tire inflation pressure/
    min.: -100 kPa (-1 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire pressure
    If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*
    ID4 Tire Inflation Pressure
    ID4 tire inflation pressure/
    min.: -100 kPa (-1 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire pressure
    If -100 kPa (-1 kgf/cm2, -14 psi) is displayed, the data has not been received.*

    HINT:
    *: It may take about 2 or 3 minutes until the values are displayed.

    OK:
    All tire pressure readings are equal to the actual tire pressure.



NG
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
OK

END