Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > REGISTRATION

for Preparation Click here



1. IN CASE OF TIRE PRESSURE WARNING ECU AND RECEIVER REPLACEMENT
  1. Read ID stored in the old ECU using the intelligent tester.



2. IN CASE OF TIRE PRESSURE WARNING VALVE AND TRANSMITTER
  1. Read the ID written on the tire wheel.



3. REGISTER TRANSMITTER ID

NOTICE:
It is necessary to register the transmitter ID in the tire pressure warning ECU and receiver when replacing the tire wheel and/or tire pressure warning ECU and receiver.

  1. Prepare all of the transmitter ID data before starting registration.

    HINT:
    1. Read the registered transmitter IDs that are stored in the ECU using the intelligent tester and make a note of them.
    2. If reading stored transmitter IDs is impossible due to malfunctions of components such as the tire pressure warning antenna and receiver, replace the tire wheel.
    3. When replacing the tire wheel, write down the IDs from the sticker on the inside surface of the tire wheel.

  1. Set the tire pressure of all wheels (including the spare tire) to the specified value.

    Standard pressure:
    220 kPa (2.2 kgf/cm2, 32 psi)

  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and the tester on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List. Then, press "Utility" to move to next screen.

  1. Perform the following procedures displayed on the tester.

  1. Input the IDs (ID1 to ID4) using the tester and transmit them to the tire pressure warning ECU and receiver. Then press "Next".

    HINT:
    If this step is not completed within 300 seconds, this mode will be canceled.

  1. "ID Registration is complete" screen is displayed. Then, press "Exit".

    HINT:
    1. The previously registered IDs will be deleted from the memory when the registration is completed.
    2. When the system is in initialization mode after the tire pressure warning reset switch has been operated, the registration is disabled until the initialization process is canceled or completed.



4. CONFIRMATION OF TRANSMITTER ID REGISTRATION
  1. Set the tire pressure of all wheels (including the spare tire) to the specified value.

    Standard pressure:
    220 kPa (2.2 kgf/cm2, 32 psi)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Select "SIGNAL CHECK" mode on the intelligent tester (Click here).

  1. Confirm that the transmitter IDs and tire pressure data for all the tires are displayed on the intelligent tester screen.

    NOTICE:
    1. It may take up to 1 minute to update the tire pressure data.
    2. If the IDs have not been registered, DTC C2171/71 is set in the tire pressure warning ECU and receiver after approximately 60 minutes.