Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TEST MODE PROCEDURE

for Preparation Click here



PERFORM SIGNAL CHECK
B127990E01

HINT:
  1. When entering the signal check, the tire pressure warning ECU and receiver sets all the signal check DTCs first. After completing the signal check for each inspection item, the DTCs that are determined normal by the tire pressure warning ECU and receiver will be erased. The DTCs for other inspection items may not be erased when only a certain signal is inspected.
  1. When the signal check returns back to normal mode, all the signal check DTCs will be erased.

  1. Make sure that the ignition switch is off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG).

  4. Select SIGNAL CHECK on the intelligent tester.

  5. Drive the vehicle at 12 mph (20 km/h) or more for 10 seconds or more.

  6. Loosen the valve core and rapidly reduce the pressure (above 40 kPa / 30 seconds or more).

    HINT:
    The transmitter ID can be transmitted by rapidly reducing the tire pressure.

  7. Check that the tire pressure warning system test mode DTCs are erased.

    Signal Check DTC
    Test Signal
    Signal Check DTC Clear Condition
    C2181
    Transmitter Data
    Receive DATA from transmitter which has a registered ID in tire pressure warning ECU and receiver
    C2191
    Vehicle Speed Signal
    Vehicle speed of 12 mph (20 km/h) or more is detected for 3 seconds or more

  8. Result

    HINT:
    After the signal check is completed, check for a DTC and signal check DTC to confirm the system status.

    Condition
    Procedure
    SIGNAL CHECK DTC is output
    Repair faulty part and enter SIGNAL CHECK again
    SIGNAL CHECK DTCs are cleared
    No problem

  9. End of SIGNAL CHECK
    After completing test mode (SIGNAL CHECK), turn the ignition switch off and disconnect the tester.

    DTC of SIGNAL CHECK (TEST DIAGNOSIS) function:
    If a malfunction code is displayed during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to the "see page" of the "DTC Code" in the chart.


    DTC Code
    Detection Item
    Trouble Area
    See page
    C2181/81
    Transmitter ID1 not received
    1. Tire pressure warning valve and transmitter
    2. Tire pressure warning antenna
    3. Tire pressure warning ECU and receiver
    4. Wire harness
    Click here
    C2182/82
    Transmitter ID2 not received
    1. Tire pressure warning valve and transmitter
    2. Tire pressure warning antenna
    3. Tire pressure warning ECU and receiver
    4. Wire harness
    Click here
    C2183/83
    Transmitter ID3 not received
    1. Tire pressure warning valve and transmitter
    2. Tire pressure warning antenna
    3. Tire pressure warning ECU and receiver
    4. Wire harness
    Click here
    C2184/84
    Transmitter ID4 not received
    1. Tire pressure warning valve and transmitter
    2. Tire pressure warning antenna
    3. Tire pressure warning ECU and receiver
    4. Wire harness
    Click here
    C2191/91
    Vehicle speed signal error
    1. Vehicle speed sensor
    1. Combination meter
    1. Tire pressure warning ECU and receiver
    1. Wire harness
    Click here
    C2195/95
    Multi-receiver antenna circuit
    1. Tire pressure warning antenna
    1. Tire pressure warning ECU and receiver
    1. Wire harness
    Click here