Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1620/21    Driver Side - Side Airbag Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

The driver side - side airbag sensor consists of parts including the diagnostic circuit and the lateral deceleration sensor.
When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1620/21 is set when a malfunction is detected in the driver side - side airbag sensor circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1620/21
When one of following conditions is met:
  1. Driver side - side airbag sensor malfunction
  2. Center airbag sensor malfunction
  1. Side airbag sensor LH (Driver side-side airbag sensor) (for LHD)
  2. Side airbag sensor RH (Driver side-side airbag sensor) (for RHD)
  3. Center airbag sensor assembly

WIRING DIAGRAM


C123544E01


INSPECTION PROCEDURE

1.CHECK DRIVER SIDE - SIDE AIRBAG SENSOR
H100840E04
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Interchange the driver side - side airbag sensor with the front passenger side - side airbag sensor and connect the connectors to them.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check the DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1620/21 and B1625/22 are not output.
    A
    DTC B1620/21 is output.
    B
    DTC B1625/22 is output.
    C

    HINT:
    DTCs other than DTC B1620/21 and B1625/22 may be output at this time, but they are not related to this check.



B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY

C
REPLACE DRIVER SIDE - SIDE AIRBAG SENSOR
A

USE SIMULATION METHOD TO CHECK