Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1630/23    Driver Side Rear Airbag Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

The driver side rear airbag sensor consists of parts including the diagnostic circuit and the lateral deceleration sensor.
When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1630/23 is recorded when a malfunction is detected in the driver side rear airbag sensor circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1630/23
When one of following conditions is met:
  1. Driver side rear airbag sensor malfunction
  2. Center airbag sensor malfunction
  1. Rear airbag sensor LH (Driver side rear airbag sensor) (for LHD)
  2. Rear airbag sensor RH (Driver side rear airbag sensor) (for RHD)
  3. Center airbag sensor

WIRING DIAGRAM


C123544E01


INSPECTION PROCEDURE

1.CHECK DRIVER SIDE REAR AIRBAG SENSOR
C131092E01
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Interchange the driver side rear airbag sensor with the front passenger side rear airbag sensor and connect the connectors to them.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check the DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1630/23 and B1635/24 are not output.
    A
    DTC B1630/23 is output.
    B
    DTC B1635/24 is output.
    C

    HINT:
    DTCs other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.



B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY

C
REPLACE DRIVER SIDE - REAR AIRBAG SENSOR
A

USE SIMULATION METHOD TO CHECK