Home › ENGINE · 2AD-FTV › STARTING › GLOW PLUG

GLOW PLUG > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the No. 1 glow plug connector (Click here).



2. CHECK GLOW PLUG ASSEMBLY


    A197252
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Glow plug terminal - Body ground
    20°C (68°F)
    0.7 Ω or higher

    If the result is not as specified, replace the glow plug assembly.

    NOTICE:
    1. Be careful not to damage the glow plug as this may cause an open circuit or shorten the life of the glow plugs.
    2. Do not allow oil or gasoline to contact the glow plug when cleaning it.
    3. Clean any oil on the terminal and bakelite washer with a dry cloth.



3. INSTALL NO. 1 GLOW PLUG CONNECTOR
  1. Install the No. 1 glow plug connector (Click here).