Home › ENGINE ยท 2AD-FTV › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A102906
  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A203116
  1. Install the sensor with the bolt.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

  1. Connect the sensor wire harness clamp.

  1. Connect the sensor connector to the bracket.

  1. Connect the sensor connector.



2. INSTALL GENERATOR ASSEMBLY
  1. Install the generator assembly (Click here).