PARKING BRAKE CABLE > INSTALLATION |
| 1. INSTALL PARKING BRAKE CABLE |
Connect the cable to the backing plate and parking brake shoe lever.
Pass the cable through the backing plate, and then connect the cable to the lever.
Install the cable to the backing plate with the bolt.

Install the clamp and clamp bolt (labeled F) to the trailing arm.
Install the clamp and clamp bolt (labeled E) to the rear suspension crossmember.
Install the clamp and clamp bolt (labeled D) to the crossmember.
Install the clamp and clamp bolt (labeled C) to the body.
Install the casing cap and casing cap bolt (labeled B) to the body.
Install the cable clamp (labeled A) to the body.
| 2. INSTALL PARKING BRAKE EQUALIZER |
![]() |
Connect the 3 cable ends to the equalizer.
| 3. INSTALL REAR WHEEL |
| 4. ADJUST PARKING BRAKE LEVER TRAVEL |
![]() |
Turn the No. 1 wire adjusting nut until the lever travel is correct.
Tighten the lock nut.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
When operating the parking brake lever, check that the brake warning light illuminates at the first click.
| 5. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
Install the center airbag sensor (Click here).