Home › ENGINE · 2AD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (for DPF)

DTC    P1625    Idle Signal Transmitter Circuit

for Preparation Click here


DESCRIPTION

The ECM reduces injector operation speed and applied voltage to the injector to reduce the sound it produces during idling. To do this, the ECM outputs applied voltage switching signals to terminal IJEN of the EDU from terminal IDLO of the ECM.

P1625 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Warm up the engine and idle it for 5 seconds
Either condition is met:
  1. With the engine running at idle, voltage of the ECM IDLO terminal is 0.05 V or less for 5 seconds or more (1 trip detection logic).
  2. With the engine running at speeds higher than idle, voltage of the ECM IDLO terminal is 3.4 V or higher for 5 seconds or higher (1 trip detection logic).
  1. Open or short in idle control circuit
  2. EDU
  3. ECM

WIRING DIAGRAM


A205143E03


INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

1.CHECK HARNESS AND CONNECTOR (EDU - ECM)


    A204912E06
  1. Disconnect the EDU connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    B104-2 - B32-62 (ILDO)
    Always
    Below 1 Ω

    Standard Resistance (Check for Short):
    Tester Connection
    Condition
    Specified Condition
    B104-2 or B32-62 (ILDO) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to EDU)
    *2
    Front view of wire harness connector
    (to ECM)

  1. Reconnect the EDU connector.

  1. Reconnect the ECM connector.



NG
Go to step 5
OK


2.REPLACE EDU
  1. Replace the EDU (Click here).


NEXT


3.CHECK ANY OTHER DTCS OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.
    Result 
    Result
    Proceed to
    No DTC output
    A
    P1625 is output
    B



B
Go to step 4
A

END 

4.REPLACE ECM
  1. Replace the ECM (Click here).



NEXT
Go to step 6

5.REPAIR OR REPLACE HARNESS OR CONNECTOR
  1. Repair or replace the harness or connector.


NEXT


6.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the intelligent tester to the DLC3.

  1. Clear the DTCs (Click here).

  1. After warming up the engine, idle the engine for 5 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Confirm that the DTC is not output again.


NEXT

END