DTC P1625 Idle Signal Transmitter Circuit |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Warm up the engine and idle it for 5 seconds | Either condition is met:
|
|

| 1.CHECK HARNESS AND CONNECTOR (EDU - ECM) |
![]() |
Disconnect the EDU connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B104-2 - B32-62 (ILDO) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| B104-2 or B32-62 (ILDO) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to EDU) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the EDU connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 2.REPLACE EDU |
Replace the EDU (Click here).
| NEXT | |
| 3.CHECK ANY OTHER DTCS OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| No DTC output | A |
| P1625 is output | B |
|
| ||||
| A | ||
| ||
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 6.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
After warming up the engine, idle the engine for 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||