Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here ).



1. INSTALL ROOF SIDE RAIL BRACKET LH


B137536
Install the bracket with the 2 bolts.

Torque:
14 N*m{ 143 kgf*cm , 10 ft.*lbf }



2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH



B137332E02



B137333E01

  1. Short body:
    Install the curtain shield airbag with the 9 bolts.
    Long body:
    Install the curtain shield airbag with the 10 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



3. INSTALL ROOF HEADLINING ASSEMBLY
  1. Short body:
    Install the roof headlining (Click here).

  1. Long body:
    Install the roof headlining (Click here).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).