Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE ROOF HEADLINING ASSEMBLY
  1. Short body:
    Remove the roof headlining (Click here).

  1. Long body:
    Remove the roof headlining (Click here).



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH



B137332E02



B137333E01

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Shot body:
    Remove the 9 bolts and curtain shield airbag.

  1. Long body:
    Remove the 10 bolts and curtain shield airbag.



4. REMOVE ROOF SIDE RAIL BRACKET LH


    B137536
  1. Remove the 2 bolt and bracket.