DTC C1249/49 Open in Stop Light Switch Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1249/49 | When IG1 terminal voltage is 9.5 to 18.5 V, open circuit of stop light switch continues for 3 seconds or more. |
|

| 1.CHECK STOP LIGHT OPERATION |
Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
| Condition | Illumination Condition |
| Brake pedal depressed | ON |
| Brake pedal released | OFF |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (STP VOLTAGE) |
![]() |
Disconnect the A27 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-10 (STP) - Body ground | Brake pedal depressed | 8 to 14 V |
| A27-10 (STP) - Body ground | Brake pedal released | Below 1.5 V |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||
| 4.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin not pushed | Below 1 Ω |
| Pin pushed | 10 kΩ or higher | |
| 3 - 4 | Pin not pushed | 10 kΩ or higher |
| Pin pushed | Below 1 Ω |
|
| ||||
| OK | ||
| ||