Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > INSTALLATION

for Preparation Click here



1. INSTALL SLIDING ROOF WEATHERSTRIP


  1. Install the sliding roof weatherstrip.


    B105392E02


    1. Position the joint of the weatherstrip at the rear center.

    2. Align the marks on the weatherstrip with the middle marks at the corners of the plastic on the edge of the sliding roof panel and install the weatherstrip. Make sure that the marks on the weatherstrip are positioned within the area indicated by the marks at the corners of the plastic on the edge of the sliding roof panel.

    3. Install the lip of the weatherstrip firmly.



2. INSTALL SLIDING ROOF HOUSING ASSEMBLY


B129368
  1. Install the housing with the 4 bolts and 8 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. CONNECT SLIDING ROOF DRAIN HOSE


B122242E02
  1. Connect the 4 drain hoses.

    NOTICE:
    The clip must face toward the outside of the vehicle and also be above the lower surface of the sliding roof housing when installing the drain hoses.



4. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY


B129372
  1. Using a T25 "TORX" driver, temporarily install the sliding roof glass sub-assembly with the 4 screws.



    B122199E02
  1. Perform a level check.

    1. Check the difference in level for "a" between the roof panel and the upper surface of the weatherstrip when the sliding roof glass is fully closed.

      Standard measurement:
      Area
      Specified Condition
      A - A
      0 + 1.5 mm (0 + 0.059 in.)
      0 - 1.5 mm (0 - 0.059 in.)
      B - B
      0 + 1.5 mm (0 + 0.059 in.)
      0 - 1.5 mm (0 - 0.059 in.)
      C - C
      0 + 1.5 mm (0 + 0.059 in.)
      0 - 1.5 mm (0 - 0.059 in.)
      D - D
      0 + 1.5 mm (0 + 0.059 in.)
      0 - 1.0 mm (0 - 0.039 in.)

      HINT:
      "+" represents the condition that the glass is above the panel level. "-" represents the condition that the glass is below the panel level.



    B122200E02
  1. Perform a gap check.

    1. Check the gap between the roof panel and roof glass.

      NOTICE:
      The gap must be even all around.



    B129372
  1. Using a T25 "TORX" driver, install the sliding roof glass with the 4 screws.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



5. INSTALL SLIDING ROOF SIDE GARNISH LH


B129367
  1. Attach the claws to install the garnish.



6. INSTALL SLIDING ROOF SIDE GARNISH RH

HINT:
Use the same procedures described for the LH side.



7. INSPECT FOR WATER LEAKS
  1. Adjust the sliding roof glass sub-assembly, and inspect for water leaks.

  1. If there are any leaks, readjust the sliding roof glass sub-assembly.



8. INSTALL ROOF HEADLINING ASSEMBLY (for Short Body)
  1. Install the roof headlining (Click here).



9. INSTALL ROOF HEADLINING ASSEMBLY (for Long Body)
  1. Install the roof headlining (Click here).



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL