DTC P2769 Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) |
DTC P2770 Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P2769 | TCM detects a short in the shift solenoid valve SL circuit when shift solenoid valve SL is operated (2-trip detection logic). |
|
| P2770 | TCM detects an open in the shift solenoid valve SL circuit when shift solenoid valve SL is not operated (2-trip detection logic). |
|
| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL) |
![]() |
Remove the TCM.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | Component without TCM connected (Transmission Wire) |
|
| ||||
| OK | ||
| ||
| 2.INSPECT SHIFT SOLENOID VALVE SL |
![]() |
Remove shift solenoid valve SL.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Shift solenoid valve SL connector terminal - Shift solenoid valve SL body | 20°C (68°F) | 11 to 15 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes an operating noise |
| *1 | Component without harness connected (Shift Solenoid Valve SL) |
|
| ||||
| OK | ||
| ||