Home › ENGINE ยท 2AD-FHV › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM


    A124573
  1. Install the 2 ECM brackets with the 4 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



    A124572
  1. Connect the 2 ECM connectors.

    1. Connect the 2 connectors to the ECM and lower the 2 levers.

      NOTICE:
      Make sure that the 2 levers are securely lowered.



    A124570
  1. Install the ECM with the 3 bolts.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }



2. INSTALL AIR CLEANER CASE


    A208831
  1. Attach the clamp and install the air cleaner case with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Connect the air cleaner hose.



    A208843E01
  1. Attach the 3 clips to install the air cleaner cap.

  1. Connect the PCV hose.

  1. Attach the clamp and connect the mass air flow meter connector.



5. INSTALL NO. 1 ENGINE COVER


    A203808
  1. Attach the 4 clips to install the engine cover.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM REGISTRATION
  1. Perform learning values write .

  1. w/ Cruise Control System:
    When replacing the ECM, perform vehicle stability control system recognition in ECM (Click here).



8. PERFORM INITIALIZATION
  1. Perform the supply pump initialization procedure (Click here)



9. PERFORM THROTTLE VALVE FULLY CLOSED POSITION LEARNING

HINT:
Be sure to turn off the ignition switch before performing this inspection.

  1. Turn the ignition switch to ON.

  1. Turn the ignition switch off and wait 10 seconds.

    HINT:
    The fully closed position of the diesel throttle valve is learned when the ignition switch is turned off.