DTC B2789 No Response from ID BOX |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2789 | Certification ECU does not receive LIN communication signals from ID code box via LIN for 10 seconds |
|

| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for the DTC.
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (CERTIFICATION ECU - ID CODE BOX) |

Disconnect the E63 ECU connector.
Disconnect the E51 box connector.
Measure the resistance of the wire harness connectors.
| Tester Connection | Specified Condition |
| LIN (E63-10) - LIN1 (E51-3) | Below 1 Ω |
| LIN (E63-10) or LIN1 (E51-3) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK ECU AGGREGATION BOX (OPERATION) |
Temporarily replace the ECU aggregation box (certification ECU) with a new or normally functioning one.
Check for a DTC.
|
| ||||
| OK | ||
| ||