DTC B2797 Communication Malfunction No. 1 |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2797 | Keys are positioned too close to each other, or noise occurred in communication line |
|

| 1.CHECK KEY |
![]() |
Check if the ignition key being used is near other ignition keys. Also, check if the key ring is in contact with the key grip.
| Result | Proceed to |
| Key is near other keys and/or key ring is in contact with key grip | A |
| Key is not near other keys and/or key ring is not in contact with key grip | B |
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Separate the keys from each other and/or remove the key ring.
Clear the DTC (Click here).
Insert a key into the ignition key cylinder. Remove it. Repeat for all other keys.
Check that no DTC is output.
|
| ||||
| NG | |
| 3.CHECK TRANSPONDER KEY ECU (NOISE) |
![]() |
Using an oscilloscope or the intelligent tester, check for noise in the waveform between the terminals of the E8 amplifier connector and E50 ECU connector.
| Tester Connection | Tool Setting | Tool Setting | Specified Condition |
| E50-15 (CODE) - E8-4 (CODE) | 5 V/DIV., 20 msec./DIV. | Key inserted | No noise is present |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
![]() |
Disconnect the E50 ECU connector.
Disconnect the E8 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E50-15 (CODE) - E8-4 (CODE) | Below 1 Ω |
| E50-15 (CODE) or E8-4 (CODE) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK TRANSPONDER KEY AMPLIFIER (OPERATION) |
Temporarily replace the transponder key amplifier with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||