Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

DTC    B2763    Intrusion Sensor +B Circuit Malfunction (GND Short)


DESCRIPTION

This DTC is output when the S+B line, which is the power supply line to the intrusion sensor (built into overhead junction block), is shorted.

DTC No.
DTC Detection Condition
Trouble Area
B2763
S+B line is shorted
  1. Wire harness
  2. Overhead junction block (intrusion sensor)
  3. Theft warning ECU

WIRING DIAGRAM


B132256E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (OVERHEAD JUNCTION BLOCK - THEFT WARNING ECU AND BODY GROUND)
B132258E02
  1. Disconnect the R8 junction block connector.

  1. Disconnect the E83 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R8-5 (S+B) - E83-21 (S+B)
    Below 1 Ω
    R8-7 (GND) - Body ground
    R8-5 (S+B) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK OVERHEAD JUNCTION BLOCK (OPERATION)
  1. Temporarily replace the overhead junction (intrusion sensor) with a new or normally functioning one (Click here ).

  1. Check for a DTC.

    OK:
    DTC B2763 is not output.



NG
REPLACE THEFT WARNING ECU
OK

END (INTRUSION SENSOR IS DEFECTIVE)