Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

DTC    B2761    Intrusion Sensor Internal Circuit Malfunction


DESCRIPTION

The intrusion sensor (built into the overhead junction block) conducts a self-diagnosis immediately after the power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the intrusion wave transmission or wave reception, or the intrusion sensor wave transmission or wave reception circuit, the intrusion sensor sends a signal to the theft warning ECU. The ECU then outputs this DTC.

DTC No.
DTC Detection Condition
Trouble Area
B2761
Intrusion sensor outputs signal for sensor malfunction
  1. Overhead junction block (intrusion sensor)
  2. Theft warning ECU

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here)

  1. Set the theft deterrent system and check for a DTC.

    OK:
    DTC B2761 is not output.



OK
END
NG


2.CHECK OVERHEAD JUNCTION BLOCK (OPERATION)
  1. Temporarily replace the overhead junction block (intrusion sensor) with a new or normally functioning one (Click here).

  1. Check for a DTC.

    OK:
    DTC B2761 is not output.



NG
REPLACE THEFT WARNING ECU
OK

END (INTRUSION SENSOR IS DEFECTIVE)