Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM (w/ Rain Sensor)

WIPER AND WASHER SYSTEM (w/ Rain Sensor) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the wiper and washer system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester (with CAN VIM) to check if the CAN communication system is functioning normally.
      Result  
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE

      Result  
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END