Home › DRIVE LINE › GF1A TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER ASSEMBLY


C126622
  1. Install the transfer to the transaxle with the 6 nuts and 2 bolts.

    Torque:
    69 N*m{ 700 kgf*cm , 51 ft.*lbf }



2. INSTALL REAR ENGINE MOUNTING BRACKET
  1. for EA64F:
    Install the rear engine mounting bracket .

  1. for U660F:
    Install the rear engine mounting bracket .



3. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
  1. for 2AD-FTV:
    Install the engine assembly with transaxle (Click here).

  1. for 2AD-FHV:
    Install the engine assembly with transaxle (Click here).



4. ADD TRANSFER OIL
  1. Remove the case plug (for filler) and gasket.

  1. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.

    NOTICE:
    1. When adding oil, pour it slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new gasket and the case plug (for filler).

    Torque:
    39 N*m{ 398 kgf*cm , 28 ft.*lbf }



5. INSPECT TRANSFER OIL


    C110905
  1. Remove the transfer case plug No. 2 (for filler) and gasket.

  1. Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
    If the result is not as specified, add transfer oil.

    Oil grade:
    Hypoid gear oil SX API GL-5 or equivalent

    Viscosity:
    SAE 85W-90

    Standard capacity:
    0.45 liter (0.48 US qts, 0.40 Imp. qts)

    NOTICE:
    1. When adding oil, pour it slowly.
    2. Too much or too little oil will lead to transfer problems.

  1. When the oil level is too low, check for oil leakage.

  1. Install a new gasket into the case plug (for filler) and then install the plug.

    Torque:
    39 N*m{ 398 kgf*cm , 28 ft.*lbf }



6. INSPECT SRS WARNING LIGHT
Check the SRS warning light (Click here).