Home › DRIVE LINE › GF1A TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DRAIN TRANSFER OIL
  1. Remove the drain plug and gasket, and drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



3. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. for 2AD-FTV:
    Remove the engine assembly with transaxle (Click here).

  1. for 2AD-FHV:
    Remove the engine assembly with transaxle (Click here).



4. REMOVE REAR ENGINE MOUNTING BRACKET
  1. for EA64F:
    Remove the rear engine mounting bracket .

  1. for U660F:
    Remove the rear engine mounting bracket .



5. REMOVE TRANSFER ASSEMBLY


C126622
  1. Remove the 6 nuts, 2 bolts and transfer from the transaxle.