Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System)

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is output when the applicable RDA signal cannot be received within 1 second of PRG signal being output from the main body ECU.

DTC No.
DTC Detection Condition
Trouble Area
B1242
In diagnostic mode, applicable RDA signal cannot be received within 1 second of PRG signal being output from main body ECU
  1. Wire harness
  2. Door control receiver
  3. Instrument panel junction block (main body ECU)

WIRING DIAGRAM


B112261E09


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (MAIN BODY ECU - DOOR CONTROL RECEIVER)
B130249E04
  1. Disconnect the E20 ECU connector.

  1. Disconnect the L10 receiver connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E20-5 (RDA) - L10-2 (RDA)
    Below 1 Ω
    E20-6 (PRG) - L10-3 (PRG)
    E20-5 (RDA) or L10-2 (RDA) - Body ground
    10 kΩ or higher
    E20-6 (PRG) or L10-3 (PRG) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK WIRE HARNESS (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)
B129963E01
  1. Disconnect the L10 receiver connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    L10-1 (GND) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Specified Condition
    L10-5 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.REPLACE DOOR CONTROL RECEIVER
  1. Temporarily replace the door control receiver with a new or normally functioning one (Click here, Click here).

  1. Perform the REGISTRATION procedures.


NEXT


4.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for DTC.

    OK:
    DTC B1242 is not output.



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)