Home › TRANSMISSION ยท EA64 MANUAL TRANSAXLE › MANUAL TRANSAXLE ASSEMBLY

MANUAL TRANSAXLE ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. DRAIN TRANSAXLE OIL
  1. Remove the filler plug and gasket.

  1. Remove the drain plug and gasket, and drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



3. DISCONNECT CLUTCH RELEASE CYLINDER


C127500
  1. Remove the 2 bolts and clutch release cylinder.



4. REMOVE STARTER ASSEMBLY
  1. Remove the starter (Click here).



5. REMOVE NO. 1 AIR TUBE


    A208841
  1. Loosen the hose clamp.

  1. Remove the 2 bolts and No. 1 air tube.



6. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY


C127238E02
  1. Remove the 2 clips and 2 washers, and disconnect the 2 cables from the transaxle.

  1. Remove the 2 clips, and disconnect the 2 cables from the bracket.



7. REMOVE ENGINE ASSEMBLY WITH MANUAL TRANSAXLE
  1. Remove the engine with transaxle (Click here).



8. REMOVE ENGINE MOUNTING BRACKET LH


C129227
  1. Remove the 4 bolts and mounting bracket.



9. REMOVE OIL PAN INSULATOR


C127239
  1. Remove the 2 bolts and insulator from the stiffener plate.



10. REMOVE STIFFENER PLATE LH


C127240
  1. Remove the 4 bolts and stiffener plate from the engine and transaxle assembly.



11. REMOVE STIFFENER PLATE RH


C127241
  1. Remove the 4 bolts and stiffener plate from the engine and transaxle assembly.



12. REMOVE MANUAL TRANSAXLE ASSEMBLY


C112442
  1. Remove the 5 bolts.

  1. Separate and remove the transaxle from the engine.



13. REMOVE FRONT ENGINE MOUNTING BRACKET


C129225
  1. Remove the 3 bolts and mounting bracket.



14. REMOVE REAR ENGINE MOUNTING BRACKET


C217401
  1. Remove the 4 bolts and mounting bracket.