Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The inner rear view mirror assembly receives a reverse signal from the park/neutral position switch assembly*1 or back-up light switch assembly*2.
  1. *1: except Manual Transaxle
  2. *2: for Manual Transaxle

WIRING DIAGRAM


B138818E32


B138818E18


INSPECTION PROCEDURE

1.CHECK INNER REAR VIEW MIRROR ASSEMBLY


    E168297E05
  1. Disconnect the R11 inner rear view mirror assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R11-3 (REV) - Body ground
    Ignition switch ON, shift lever in R
    11 to 14 V
    R11-3 (REV) - Body ground
    Ignition switch ON, shift lever not in R
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK VEHICLE TYPE
  1. Check the vehicle type.
    Result 
    Result
    Proceed to
    except Manual Transaxle
    A
    for Manual Transaxle
    B



B
Go to step 4
A


3.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)


    E168287E07
  1. Disconnect the R11 inner rear view mirror assembly connector.

  1. Disconnect the B28 park/neutral position switch assembly connector.

  1. Measure the resistance the according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R11-3 (REV) - B28-2 (RL)
    Always
    Below 1 Ω
    R11-3 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)  

4.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BACK-UP LIGHT SWITCH ASSEMBLY)
E181286E02
  1. Disconnect the R11 inner rear view mirror assembly connector.

  1. Disconnect the B25 back-up light switch assembly connector.

  1. Measure the resistance the according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R11-3 (REV) - B25-1
    Always
    Below 1 Ω
    R11-3 (REV) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for EA64F)
    A
    OK (for EA64)
    B
    NG
    C



B
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)