DTC C1296/96 ABS Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1296/96 | When either conditions below is met:
|
|
| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG) again and check that CAN communication system DTC(s) is not output.
Drive the vehicle, accelerate to a speed of 20 km/h (12 mph) or more, and check if the speed sensor DTC (brake control system DTC) is output (Click here, and Click here).
| Result | Proceed to |
| Neither CAN communication system DTC brake control system DTC is not output | A |
| CAN communication system DTC is output | B |
| Brake control system DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK OPERATION OF 4WD CONTROL ECU |
Replace the 4WD control ECU with a normally functioning or new one.
Reconfirm DTC.
|
| ||||
| NG | ||
| ||