ACTIVE TORQUE CONTROL 4WD SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| CHECK DLC3 |
![]() |
The vehicle's ECU uses the ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
Verify the conditions listed in the table below.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus + line | During transmission | Pulse generation |
| CG (4) - Body Ground | Chassis ground | Always | Below 1Ω |
| SG (5) - Body Ground | Signal ground | Always | Below 1Ω |
| BAT (16) - Body Ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch off * | 54 to 69 Ω |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Ignition switch off * | 1 MΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch off * | 200 Ω or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Ignition switch off * | 1 MΩ or higher |
| CANL (14) -CG (4) | LOW-level CAN bus line | Ignition switch off * | 200 Ω or higher |
| FUNCTION OF 4WD INDICATOR LIGHT |
The 4WD indicator light in the combination meter (multi-information display) warns the driver of abnormal or poor condition of the 4WD control system.
w/o Multi-information display:
If the 4WD control ECU detects a malfunction, the 4WD indicator lights comes on in accordance with the trouble area to warn the driver.
w/ Multi-information display:
If the 4WD control ECU detects a malfunction, the check master caution indicator comes on (*1) and the multi-information display displays warning messages (*2) in accordance with the trouble area to warn the driver.

| CHECK 4WD INDICATOR LIGHT (w/ Multi-information Display) |
![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3 (to enter diagnostic mode).
Turn the ignition switch on (IG).
![]() ![]() |
"DIAG" is displayed on the multi-information display, and the 4WD control ECU checks the system for malfunctions.
![]() |
| Trouble Area | See procedure |
| 4WD indicator light (Remains on) |
Click here
|
| 4WD indicator light (Does not come on) |
Click here
|