Home › RESTRAINTS › SEAT BELT › REAR CENTER SEAT OUTER BELT ASSEMBLY

REAR CENTER SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE SHOULDER BELT ANCHOR COVER RH


B133646E01
  1. Using a screwdriver, remove the 4 claws and cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE ROOF HEADLINING ASSEMBLY (for Short Body)

HINT:
It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining.

  1. Partially remove the roof headlining (Click here).



4. REMOVE ROOF HEADLINING ASSEMBLY (for Long Body)

HINT:
It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining.

  1. Partially remove the roof headlining (Click here).



5. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for Short Body)


B130996
  1. Remove the 2 bolts and seat belt.



6. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for Long Body)
  1. Remove the 2 bolts and seat belt.