REAR AXLE HUB > INSTALLATION |
| 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH |
![]() |
for 2WD:
Install the axle hub and bearing to the axle carrier with the 4 bolts.
![]() |
for 4WD:
Align the shaft splines and drive in the drive shaft to the axle hub and bearing.
Install the axle hub and bearing to the axle carrier with the 4 bolts.
| 2. CONNECT REAR SHOCK ABSORBER ASSEMBLY LH |
Install the shock absorber with bracket to the axle carrier with the 2 bolts.
| 3. TEMPORARILY INSTALL REAR SUSPENSION NO. 1 ARM ASSEMBLY LH |
![]() |
Temporarily install the suspension arm with the bolt and 2 nuts to the suspension member and axle carrier.
| 4. INSTALL SKID CONTROL SENSOR WIRE (for 2WD) |
![]() |
Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
Install the sensor clamp (labeled B) with the bolt (labeled C).
![]() |
Install the sensor clamps (labeled D) with the 2 nuts (labeled E).
Install the sensor clamp (labeled F) with the bolt (labeled G).
![]() |
Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
![]() |
Connect the skid control sensor wire connector.
| 5. INSTALL REAR SPEED SENSOR LH (for 4WD) |
![]() |
Install the sensor (labeled A) with the bolt (labeled B).
Install the sensor clamp (labeled C) with the nut (labeled D).
![]() |
Install the sensor clamps (labeled E) with the 2 nuts (labeled F).
Install the sensor clamp (labeled G) with the bolt (labeled H).
![]() |
Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.
![]() |
Connect the speed sensor connector.
| 6. INSTALL REAR DISC |
![]() |
Align the matchmarks and install the disc.
| 7. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH |
Install the rear disc brake cylinder assembly (Click here).
| 8. INSTALL REAR AXLE SHAFT LH NUT (for 4WD) |
Clean the threaded parts on the drive shaft and a new axle shaft nut using a non-residue solvent.
Install a new hub nut.
![]() |
Using a chisel and hammer, stake the hub nut.
| 9. INSTALL REAR WHEEL |
| 10. INSPECT REAR WHEEL ALIGNMENT |
Inspect the rear wheel alignment (Click here).
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. CHECK SPEED SENSOR SIGNAL |
Check the speed sensor signal for ABS (Click here).
Check the speed sensor signal for VSC (Click here).