Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB

REAR AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
  1. Remove the rear disc brake cylinder assembly (Click here).



3. REMOVE REAR DISC


    C129072E01
  1. Put matchmarks on the disc and axle hub.

  1. Release the parking brake.



    C127304
  1. Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.



4. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION


    C127564E01
  1. Using a dial indicator, measure the backlash near the center of the axle hub.

    Maximum backlash:
    0.05 mm (0.00197 in.)

    If the backlash is greater than the maximum, replace the axle hub.

  1. Using a dial indicator, measure the deviation on the surface of the axle hub outside the hub bolt.

    Maximum deviation:
    for 2WD:
    0.08 mm (0.00315 in.)
    for 4WD:
    0.06 mm (0.00236 in.)

    If the deviation is greater than the maximum, replace the axle hub.



5. INSTALL REAR DISC


    C127291E01
  1. Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



6. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY
  1. Install the rear disc brake cylinder assembly (Click here).



7. INSTALL REAR WHEEL